Language
中国
韩国
韩国
韩国
韩国
韩国

东莞市金叠电子有限公司

Products

USB TYPE C HIGH SPEED UART Cable
USB TYPE C HIGH SPEED UART Cable
USB TYPE C HIGH SPEED UART Cable
USB TYPE C HIGH SPEED UART Cable
USB TYPE C HIGH SPEED UART Cable
USB TYPE C HIGH SPEED UART Cable USB TYPE C HIGH SPEED MPSSE Cable
  • Model: USB TYPE C HIGH SPEED UART Cable
  • Specification: USB TYPE C HIGH SPEED UART Cable
  • Performance:
  • Category:
  • Category: FTDI Cables
  • Share This:        

USB TYPE C HIGH SPEED UART Cable

USB TYPE C HIGH SPEED MPSSE Cable


The Hi-Speed Type C USB to MPSSE cables can be used to bridge USB to a variety of protocols including SPI, I2C, or JTAG at 3.3V logic levels.


The Type-C USB connector allows direct connection to the latest computers featuring Type C ports without requiring adapters. 

The cable has an FTDI FT232H integrated into the USB connector which handles all of the USB signalling and protocols. The FT232H includes an MPSSE serial engine which gives it the ability to emulate synchronous serial protocols. The use of the MPSSE libraries requires that FTDI's D2XX drivers are installed. 

The SPI / I2C / JTAG end of the 0.5m cable has ten single-pole female receptacles. These provide access to the ADbus lines which are used for the SPI / I2C / JTAG signals, as well as GND and VCC. 

The VCC wire provides 3.3V DC or 5V DC (depending on model) allowing external circuits to be powered. 

The Hi-Speed Type C USB to UART cables provide an easy way to connect a device which has a UART using 3.3V logic levels (such as a Microcontroller) to a computer over USB.

The Type-C USB connector allows direct connection to the latest computers featuring Type C ports without requiring adapters.

The integrated FT232H IC handles all of the USB signaling and protocols, using the FTDI Virtual COM Port or D2XX drivers on the host computer side, making the cable very easy to set up and use.

The UART end of the 1.8m cable has ten single-pole female receptacles. These provide TxD, RxD, RTS#, CTS#, DTR#, DSR#, DCD# and RI# signals as well as GND and VCC.

The cable uses UART signaling with +3.3V logic-level signals at up to 12Mbaud. The VCC wire provides 3.3V DC or 5V DC (depending on the model) allowing external circuits to be powered.  

 

Copyright 2020  Premier Cable CO.,LTD   Suport:300.cn  Dongguan     粤ICP备2020142126号 

Copyright 2020  Premier Cable CO.,LTD   

Suport:300.cn  Dongguan

粤ICP备2020142126号