Language
中国
韩国
韩国
韩国
韩国
韩国

东莞市金叠电子有限公司

Products

Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
Terminal Resistor 120 Ohm, DB9, CAN Bus
CAN Termination resistors, plugs and cables 120 Ohm for high speed CAN system CAN Bus adaptor with a 9-pin D-Sub
  • Model: D-Sub 9 pin 120 Ohm termination adapter
  • Specification: 120 Ohm for high speed CAN system
  • Performance: CAN Bus adaptor with a 9-pin D-Sub
  • Category:
  • Category: CAN Bus Cable Adapter
  • Share This:        

Terminal Resistor 120 Ohm, DB9, CAN Bus 

 

D-Sub 9 pin 120 Ohm termination adapter

 

CAN Termination resistors, plugs and cables

 

120 Ohm for high speed CAN system

 

CAN Bus adaptor with a 9-pin D-Sub

 


120 Ohm for high speed CAN systems according to ISO 11898-2 Male to female

 

Between CAN High (pin 7) and CAN Low (pin 2), there is a built-in 120 Ohm CAN Bus termination resistor.

 

D-Sub 9 pin 120 Ohm termination adapter is a CAN Bus adaptor with a 9-pin male D-Sub connector at one end and a 9-pin female D-Sub socket at the other. 

 


Why is the terminating resistor 120 ohms ?

 


Through the reasons for signal reflection, we can conclude that the resistance of the terminal resistor depends on the impedance of the cable.

 

The characteristic impedance of any cable can be obtained experimentally.

 


One end of the cable is connected to a square wave generator, the other end is connected to an adjustable resistor, and the waveform on the resistor is observed through an oscilloscope.

 


Adjust the resistance value of the resistor until the signal on the resistor is a good square wave without ringing, and the resistance value at this time can be considered to be consistent with the characteristic impedance of the cable.

 


Typical cables used in the CAN bus, twist them into twisted pairs, and the characteristic impedance can be obtained according to the above method to be about 120Ω, which is also the resistance value of the terminal resistance recommended by the CAN standard, so this 120Ω is measured. It is not calculated, it is calculated based on the actual wiring harness characteristics.

 


This is also the recommended resistance value in the CAN standard

 

CAN Bus adaptor with a 9-pin D-Sub120 Ohm for high speed CAN systemCAN Termination resistors, plugs and cablesD-Sub 9 pin 120 Ohm termination adapterTerminal Resistor 120 Ohm, DB9, CAN Bus

Copyright 2020  Premier Cable CO.,LTD   Suport:300.cn  Dongguan     粤ICP备2020142126号 

Copyright 2020  Premier Cable CO.,LTD   

Suport:300.cn  Dongguan

粤ICP备2020142126号