Language
中国
韩国
韩国
韩国
韩国
韩国

东莞市金叠电子有限公司

Products

CAN and CAN FD Test Cable
CAN and CAN FD Test Cable
CAN and CAN FD Test Cable
CAN and CAN FD Test Cable
CAN and CAN FD Test Cable
CAN and CAN FD Test Cable
CAN and CAN FD Test Cable
CAN and CAN FD Test Cable
CAN and CAN FD Test Cable
RS232 D-Sub to banana plug CAN-High and CAN-Low Test Cable CAN Bus Communication DB9 Test Cable Lead
  • Model: CAN DB9 Test Cable Lead
  • Specification: CAN Test Jumper Cable
  • Performance: CAN Bus Test Cable
  • Category:
  • Category: CAN Bus Cable Adapter
  • Share This:        

CAN Bus Test Cable        


CAN Test Jumper Cable


CAN DB9 Test Cable Lead


CAN and CAN FD Test Cable    

 

RS232 D-Sub to banana plug    


CAN-High and CAN-Low Test Cable        


CAN Bus Communication DB9 Test Cable Lead

 


Common fault detection methods in CAN bus communication  ?

  


1. When the working voltage provided by the automobile power supply system is lower than 12V, some electronic control modules will temporarily stop working, thus making the entire automobile multiplex information transmission system temporarily unable to communicate.

 

2. CAN bus communication failures are generally caused by poor line contact, line open circuit and line short circuit. In the actual maintenance, there are mostly poor contact and open circuit faults.

 

3. The faults of poor line contact mostly occur at the terminals of the CAN bus connection wires, and most of the faults occur at the line connection plug-in and the connection between the wire end terminal and the metal.
  


4. The main reasons for short-circuit faults are short-circuit faults caused by damaged electrical parts, and short-circuit faults caused by wear of wires and harnesses.

 


The detection method of the bus module :

 

1. Check whether the ECU power supply is normal and whether the voltage is the current power supply voltage.

 

2. Check whether the connection of the WAKE-UP wake-up line is normal, and the voltage is approximately equal to the power supply voltage.

 

3. Check whether the CAN-H, CAN-L wiring is normal, whether there is a 60 ohm resistance between the interfaces (4-5), and whether the connection is reversed.

 

CAN-High and CAN-Low Test Cable      CAN DB9 Test Cable LeadCAN Test Jumper CableCAN and CAN FD Test Cable
 

Copyright 2020  Premier Cable CO.,LTD   Suport:300.cn  Dongguan     粤ICP备2020142126号 

Copyright 2020  Premier Cable CO.,LTD   

Suport:300.cn  Dongguan

粤ICP备2020142126号