USB Serial Cable RS232 to Mini USB connector manufacturers take you to understand how to install cable connector
1. USB Serial Cable RS232 to Mini USB connector Manufacturers tell you that to remove the cable connector, take the detachable parts apart sequentially. Fix the end of the cable, nail it on the shaft plate, the end extends a part, and the end is inclined downward to form an included angle of about 30°-45° with the horizontal direction.
2. USB Serial Cable RS232 to Mini USB connector Manufacturers tell you that use a hand saw or an electric knife to strip off a section of the cable sheath about 45mm long, and the section should be kept straight.
3. USB Serial Cable RS232 to Mini USB connector Manufacturers tell you that apply sealant evenly around the junction of the sheath surface and the outer conductor (the part that can be covered by the back end cover of the connector) and then cover the back end of the connector. (Press the lock ring), gasket and sealing ring on the cable in sequence, and rotate the connector sleeve of the connector on the outer conductor with the sheath removed along the spiral direction of the outer conductor, close to the end of the cable sheath.
The above is the USB Serial Cable RS232 to Mini USB connector manufacturer's introduction and analysis of how to install cable connector, hope it helps you.