1. RS232 Serial Cable With RJ12 Connector Manufacturers tell you that use a copper brush to clean the cable connector. In general, the copper powder in the cable connector and the sheath of the cable should be cleaned up. Prevent short circuits or dangerous situations from occurring.

2. RS232 Serial Cable With RJ12 Connector Manufacturers tell you that connect the internal conductor components, external lightning protection components, and internal components of the cable connector accordingly. At this time, the installation must be accurate (that is, the installation sequence should also be carried out in the above order).
3. RS232 Serial Cable With RJ12 Connector Manufacturers tell you that install the inner card slot on the cable connector, and finally inflate it, be sure to charge a certain amount of dry gas. Just keep the air pressure above 90%.
The above is the RS232 Serial Cable With RJ12 Connector manufacturer's introduction and analysis of the subsequent installation process of the cable connector, hope it helps you.